I used 1 1/4″ screws and use the 3/4″ setting on the jig. There should be a chart that comes with your kreg jig that lists out all of the correct settings for different thicknesses of material as well as what screws to use. Cheers!

thanks I did it before and forgot I think I set jig 3/4 bit 5/8 with 1 1/4 screw glue. I will have to make a test
thanks

No, never heard a reply. I used alternate means trying different kreg settings and different screw size to fit the uncommon application. I cannot recall the setup as it has been some time. It worked for cornhole as I didn’t need anything more than for the pieces to attach. I also glued the pieces together to assist with attachment. Hope this helps.

I had 6in hole saw I found keep splintering I tape it or thin card board taped to it

Ebay, Etesy.com

Did you get an answer what setting use and screws on the kregg jig
attach half inch ply to 2×4

Those turned out great Jeff! Nice work!

https://uploads.disquscdn.com/images/4a0b14f529bab84f6aa559716555a1077883da1610cb8a2dfd3b18aaa6ba725e.jpg

My works too. Used WoodPrix handbooks and build it with no problems.

For ordering decals online you I usually recommend decalsextremeonline.com and vinyldisorder.com They are both good services that have reasonable prices. If you can I would recommend going to a local printer as they can print you logo in a few minutes and you can work with them on exactly what you want more easily. Hope this is helpful!

Cheers!